Professor Parabellum - The MAC- 10 Construction Guide by Practical Scrap Metal Small Arms Volume 6. 6-Professor Parabellum

Author:Practical Scrap Metal Small Arms Volume 6. 6-Professor Parabellum
Format: epub

The MAC-10 Construction Guide Lower receiver templates Bend 90 degrees Bend 95 degrees Upper rest bar hole = 4mm aoe Lower plate Lower plate continued... When cut from a single sheet of steel, the lower plate template should total 300mm in length before bending rear section. zx sazed apis WLU LZ Trigger and sear holes = 4mm Lug hole = 8mm 39mm 2 inches Print on 8.5x11 US letter paper Bottom and side plates : 2mm or 2.5mm mild steel sheet

The MAC-10 Construction Guide Rear assembly Rear sight Rear closure profile Weld Holes: 3mm Rear sight ae 65mm Lay a weld bead along each side 10mm once positioned 10mm high at rear of lower receiver Welding lower receiver plates together Position side plates and lower plate together using clamps, leaving a slight ‘trench’ between contact points to allow for adequate weld s Pointing down, lay a continuous weld beld along each side. build up. A section of 38mm box tubing can be used as a jig. Grind off excess weld and smooth over using an angle grinder fitted with a 3mm grinding disc. 2 inches Print on 8.5x11 US letter paper Rear sight : 2mm or 2.5mm mild steel plate

Download

Copyright Disclaimer:
This site does not store any files on its server. We only index and link to content provided by other sites. Please contact the content providers to delete copyright contents if any and email us, we'll remove relevant links or contents immediately.