Crafting Wooden Lamps by Ken Burton

Author:Ken Burton [Burton, Ken]
Language: eng
Format: epub
ISBN: 978-1-4403-0932-8
Publisher: F+W Media
Published: 2011-09-07T16:00:00+00:00

Cut a piece of ⅛-thick material for the cap. Cut it round on the band saw and notch it to fit around the bent piece. Drill and countersink three holes for the short screws that will hold it in place atop the disk.

Drill a 2¼”-diameter × 1½ ”-deep hole in the bottom of the base. Locate the hole as shown in the Base Section View. Chuck a ⅜ ” rabbeting bit in your table-mounted router and cut a ¼”-deep rabbet around the edge of the hole.

Drill a ½ ”-diameter hole in the concave face of the bent piece so you can get the wires out of the groove. Center it from side-to-side and locate it 1" up from the lower end of the piece. Drill a corresponding hole in the center of the notch in the base leading into the 2¼” hole you drilled earlier.

Download

Copyright Disclaimer:
This site does not store any files on its server. We only index and link to content provided by other sites. Please contact the content providers to delete copyright contents if any and email us, we'll remove relevant links or contents immediately.